Medallion L4-2165cc 2.2L (1988)
Vehicle Speed Sensor: Service and Repair
This procedure consists of replacing the road speed sensor by cutting the harness connecting the computer and the sensor. The new road
speed sensor service kit includes, one road speed sensor with a wire harness and male connector, one female connector, two male terminals
and two seals.
1. Remove road speed sensor from transaxle.
2. Cut harness the same length as the replacement harness.
3. On the computer side, remove approximately 1.6 inches of outer insulation from the cable end.
4. Remove approximately .20 inch of insulation from each wire.
5. Install a seal onto each wire.
6. Install and crimp the two male terminals onto the wire ends.
7. When installing the wires into the connector, ensure the wire color codes are not interchanged.
8. Install connector locking tab.
