Medallion L4-2165cc 22L (1988) - Oxygen Sensor Bulletin
14.
Solder wires (E) and (N) together with rosin core solder (Fig. 9).
15.
Slide the heat shrink tubing over the soldered connection. Be sure the tubing completely covers the solder joint and and any sections of bare wire.
FIGURE 10
16.
Shrink the tubing with a heat gun (R) (Fig. 10).
FIGURE 5
17.
Secure the new harness wire (E) to the radiator crossmember with tie straps (P) (Fig. 5).
FIGURE 4
18.
Coil any excess wire at the oxygen sensor and secure it with a tie strap (Q) (Fig. 4).
19.
Install the ECU cover and wingnut.
20.
Install the battery hold down bracket. Then install and connect the battery.
