Medallion L4-2165cc 2.2L (1988)
4.
Remove the battery.
5.
Mount the module (A) on the headlight panel as follows (Fig. 2):
a.
Mark a spot on the panel ledge (F) 4-inches to the left of the oval opening (G) and 3/8-inch up from the bottom of the ledge.
b.
Drill a 3.9 mm (0.1535 in) hole at the marked spot for the module mounting screw.
c.
Apply dialectric grease, P/N 812 6688, to the threads of the module mounting screw supplied in the kit.
d.
Attach the module (A) and the ground wire eyelet (B) to the panel ledge with the mounting screw.
FIGURE 3
6.
Remove the oxygen sensor connector (H) from the retainer clip on the engine block.
FIGURE 4
7.
Disconnect the oxygen sensor wire connector and install the new harness connectors (C) and (D) (Fig. 4)
