Medallion L4-2165cc 2.2L (1988)
Fig. 9 Inserting shaft yoke into housing. Type 1
13. Insert the shaft yoke (R) into the housing (S).
14. Tilt the shaft and insert one star plate arm (P) into the yoke. Then press the arm into the yoke slot using a screwdriver.
15. Remove spacer from under the star plate by pulling it out with the attached wire.
Fig. 10 Installing remaining star plates into yoke. Type 1
16. Press the remaining star plate arms into the yoke with a modified screwdriver (T). Grind approximately a 0.20 by 0.12 inch notch in the
screwdriver tip. Then seat the remaining star plate arms.
17. Ensure each star plate arm is properly seated.
18. Check spider movement. It should move freely in all directions.
19. Lubricate all constant velocity joint components.
20. Position boot into housing and shaft retaining grooves.
21. Purge air from boot. Do not damage boot when purging air.
