Medallion L4-2165cc 2.2L (1988)
Constant Velocity Joint Boot: Service and Repair
Inner CV Joint Boot Bearing
Fig. 21 Pressing boot bearing onto shaft
1. Remove constant velocity joint housing and bearing rollers.
2. Remove bearing snap ring.
3. Press bearing and boot off shaft assembly.
4. Using a suitable press and tool T.Av.944 or equivalent, install bearing and boot.
5. Install snap ring.
6. Press boot and bearing onto shaft until tool T.Av.944 bottoms against shaft. At this point, distance (C). should be approximately 5.85 inches. Do
not attempt to install the bearing with a hammer or damage may result.
7. Assembly constant velocity joint.
