Premier L4-150 2.5L (1988)
7.
Install new brake hose with the washers supplied in the package.
FIGURE 1
NOTE:
STEPS 8 THROUGH 12 MUST BE PERFORMED IN THE PROPER SEQUENCE TO AVOID INCORRECT ASSEMBLY. REFER TO
FIGURE 1 AND NOTE THE FORWARD LOOP OF THE HOSE.
8.
Finger tighten the banjo bolt to the caliper with the banjo block sandwiched between the washers. Line up anti-rotation ledge to the flat side of the
caliper boss.
9.
Rotate the hose forward until the white foam spacer just contacts the strut body.
10.
Tighten the banjo bolt to 42 N-m (31 ft.lb).
11.
Insert the hose elbow into the body bracket. Refer to Figure 1.
12.
Install the new spring clip supplied in the package to secure the elbow to the body bracket. The five-point hex will position the elbow 30~ toward
the rear of the vehicle.
13.
Tighten brake tube nut to 19 N-m (14 ft.lb).
14.
Remove brake pedal prop rod.
15.
Bleed both front brake calipers thoroughly. Refer to the 1990 Premier/Monaco Service Manual (# 81-270-0140) page 5-7 for brake bleeding
information.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
05-30-05-90 . . . . . . . . . . . . . . . . . 0.9 Hrs.
Replace both front brake hoses
NOTE:
IF REPLACEMENT OF ONLY 1 (ONE) BRAKE HOSE IS REQUIRED, REFER TO THE APPROPRIATE LABOR OPERATION
TIME SCHEDULE FOR EXISTING TIME.
FAILURE CODE:
51 - Improperly Installed
