Premier L4-150 2.5L (1988)
3. Remove two front console to bracket retaining screws.
4. Remove three armrest assembly to console retaining screws, then the armrest.
5. Remove two rear of console to bracket retaining screws.
6. Remove seat belt guide from inside console.
7. Remove console.
8. Remove two pivot bracket to knee bolster retaining bolts.
9. Loosen two pivot bracket retaining screws. Do not remove retaining screws.
10. Remove one screw and two Torx bolts retaining forward console bracket to floor.
11. Slide forward console bracket rearward.
12. Remove two knee bolster to instrument panel retaining screws from center of knee bolster.
13. Remove one knee bolster retaining screw located to left of steering column.
14. Remove one air duct to knee bolster retaining screw.
15. Remove garnish molding retaining screw located at bottom of instrument panel.
16. Remove four retaining nuts at ends of knee bolster.
17. Move knee bolster toward rear of vehicle enough to gain access to the two parking brake release handle retaining screws.
18. Remove brake handle retaining screws, then the knee bolster.
19. Remove heater core.
20. Remove vacuum and electrical connectors from A/C control module.
21. Remove A/C module retaining screws, then the module.
22. Unlock retaining tab and remove motor arm from door pivot arm.
23. Remove spring and clear vacuum line from motor.
24. Release heater core retaining tabs, then remove core.
25. Remove foam gaskets, then disconnect blower motor electrical connector.
26. Remove blower motor.
27. Remove upper to lower housing attaching screws and clips.
28. Separate upper and lower housing halves.
29. Remove evaporator core.
