Premier L4-150 2.5L (1988)
4.
Install the shield support clip on the brake pedal bracket as shown (Figure 19).
5.
Tighten the steering column attaching bolt to 33 ft. lbs. (45 Nm).
6.
Verify that the shield does not interfere with the accelerator pedal.
7.
Reinstall the A/C duct.
8.
Reconnect the negative battery cable.
D. Refill and Bleed Cooling System
NOTE:
Bleeding of the cooling system is not required for the 2.5L engine.
IMPORTANT:
It is essential that coolant does not contact the accessory drive belt or pulleys. If coolant contacts the accessory drive belt or drive pulleys,
flush them with clean water.
WARNING:
When installing drain hose to air bleed valve on thermostat housing, route hose away from accessory drive belt, accessory drive pulleys and
electric cooling fan.
