Premier L4-150 2.5L (1988)
1.
Locate oxygen sensor.
^
Premier -- in the exhaust manifold as shown in Figure 1.
^
Alliance GTA -- in exhaust pipe adapter, after exhaust manifold, as shown in Figure 2.
2.
Disconnect the oxygen sensor electrical connector.
3.
Remove oxygen sensor using a crowfoot socket.
4.
Clean threads in exhaust pipe or adapter.
5.
Install the new oxygen sensor (PN C3905920). Tighten to 22 ft.lbs. (30 N-m).
6.
Connect oxygen sensor connector.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the labor operation numbers and time allowances (see illustration).
