eagle Workshop Repair Guides

Eagle Workshop Service and Repair Manuals

Crankshaft Position Sensor - Intermittent No Start|Page 1584 > < A/T - Harsh Closed Throttle 4-3 Downshift|Page 1579
Page 1
background image

Powertrain Control Module: Customer Interest
Crankshaft Position Sensor - Intermittent No Start

Models

1988-89 Premier

Subject

Intermittent NoStart Condition

Index

DRIVEABILITY

Date

October 10, 1988

No.

18-55-88

P-4232

(C08-61)

SYMPTOM/CONDITION

Some 1988-89 Premier vehicles may experience an intermittent nostart condition during engine cranking. This condition may be caused by an inadequate
crank position sensor (CPS) signal to the engine control unit (ECU).

DIAGNOSIS

Prior to performing the procedure in this bulletin verify that the vehicle has been checked with the MS 1700 or DRB II Engine Diagnostic Tester and any
indicated malfunction corrected.

If a problem persists proceed with the following repair procedure.

PARTS REQUIRED

Patch Harness Kit:

PN 4443-965 Crank Position Sensor Patch Harness With Tie Straps (1) Separate Tie Straps (2)

FIGURE 1

REPAIR PROCEDURE

1.

Disconnect the battery negative terminal.

Crankshaft Position Sensor - Intermittent No Start|Page 1584 > < A/T - Harsh Closed Throttle 4-3 Downshift|Page 1579