eagle Workshop Repair Guides

Eagle Workshop Service and Repair Manuals

Speedometer- Intermittent Operation|Page 2204 > < A/T - Harsh Closed Throttle 4-3 Downshift|Page 2198
Page 1
background image

Speedometer Module: All Technical Service Bulletins
Speedometer- Intermittent Operation

 NO.: 08-58-90

GROUP:

ELECTRICAL

DATE:

Sept. 24, 1990

SUBJECT:

Intermittent Speedometer Operation

MODELS:

1988-90 Eagle Premier

SYMPTOM/CONDITION

Vehicle may experience an intermittent speedometer operation. This condition is caused by an inadequate speed sensor signal to the speedometer module
located in the instrument cluster.

PARTS REQUIRED

1

Speed Sensor Patch Harness

4604234

2

Tie Straps

6015756

1

Heat Shrink Tube

4419644

REPAIR PROCEDURE

1.

Disconnect the battery negative terminal.

2.

Remove the three nuts and two wiring connectors from the Engine Control Unit (ECU) and remove the ECU.

3.

Disconnect the eight way connector between the ECU wiring harness and the instrument panel wiring harness.

FIGURE 1

4.

Locate the round insulation retaining clip under the heater/air conditioner housing (Figure 1).

5.

Drill a 1/2 inch hole through the bulkhead one inch to the left of the round insulation retaining clip (Figure 1). Remove all metal burrs from around
the drilled hole.

Speedometer- Intermittent Operation|Page 2204 > < A/T - Harsh Closed Throttle 4-3 Downshift|Page 2198