Premier V6-182 3.0L SOHC (1990)
California
1990 through Early-1991 Dodge Monaco (BB) Vehicles Equipped With a 3.0L Engine Built Through October 11, 1990 and Located Outside of
California
All removed catalytic converters, and initially oxygen sensors, must be returned to the Warranty Material Return Center.
Parts and Labor
PARTS
Important:
A quantity of parts will be distributed initially and billed to all involved dealers. This quantity will cover a portion of the total vehicles involved.
Additional parts may be ordered as needed to support customer demand.
Each involved dealer, to whom vehicles in the recall were invoiced (or the current dealer at the same street address), will receive enough Emission
Service Packages, Recall P/N C3905900, to service 25% of those vehicles.
Each parts package contains the following components:
Quantity
Description
1
Oxygen Sensor
1
Catalytic Converter
1
Gasket
1
Clamp
4
Bolt
4
Nut
1
Instruction Sheet
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Replace Oxygen Sensor
25590182
0.6 Hours
and Catalytic Converter
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
PARTS RETURN
Removed catalytic converters must be returned to the Warranty Material Return Center.
Initially, a small number of oxygen sensors are required to be returned to the Warranty Material Return Center. When an adequate number of returned
parts have been accumulated, Parts Return Documents will no longer be generated and parts are to be discarded.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing and material return instructions.
Service Procedure
SERVICE PROCEDURE VIDEOTAPE
No videotape of the service procedure for this recall will be provided.
SERVICE PROCEDURE
A.
Replace Oxygen Sensor:
1.
Raise vehicle on hoist.
