Spirit L6-258 4.2L VIN C 2-bbl (1982)
15. Loosen adjuster plug and remove from housing.
16. Remove valve assembly by grasping stub shaft and pulling out.
17. Remove worm, lower thrust bearing and races from upper end of housing.
Disassemble Housing
1. Remove pitman shaft outer dust seal retaining ring.
2. Remove outer dust seal.
3. Remove seal (double lip) by inserting offset screwdriver between seal and back-up washer and prying out of housing.
4. Remove back-up washer.
5. Remove seal (single lip) by cutting and collapsing seal.
6. Remove pitman shaft needle bearings (if necessary) with a suitable driver.
7. If connectors are to be removed, tap threads in holes of connectors using 5/16-18 NF tap. Remove connectors by using threaded bolt into tapped
holes with washer and nut as extractor.
Stub Shaft & Spool Valve Removal
Fig. 10 Lower thrust bearing & adjuster assembly. Model 605
Fig. 11 Stub shaft seals & snap ring. Model 605