Summit L4-1468cc 1.5L SOHC (1989)
Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection
1. Remove sensor from intake manifold, then immerse sensing portion of sensor into a suitable heating container filled with water. Do not allow
temperature sensing portion of sensor to directly touch heated portion of container. Ensure hot water is continually stirred and connector terminal
is held approximately .12 inch above water.
2. Insert a suitable thermometer into container, then connect an ohmmeter to sensor.
3. Ohmmeter should indicate the following values:
a. At 32°F, ohmmeter should indicate 5900 ohms.
b. At 68°F, ohmmeter should indicate 2500 ohms.
c. At 104°F, ohmmeter should indicate 1100 ohms.
d. At 176°F, ohmmeter should indicate 300 ohms.
4. If resistance values are as specified, coolant temperature sensor is satisfactory. If resistance values are not as specified, replace sensor.
5. Apply a suitable sealant to threaded portion of sensor, then install and torque to 21 ft. lbs., then securely tighten harness connector.
