Summit L4-1597cc 1.6L DOHC (1990)
Transmission Position Switch/Sensor: Adjustments
1. Place selector lever in "N" (Neutral) position.
2. Place manual control lever in "N" (Neutral) position.
3. For adjustment, turn inhibitor switch body in order to align the end [12mm (.47 in.) wide area] of the manual control lever to the flange [12mm
(0.47 in.) wide area] of the inhibitor switch body.
4. Tighten the mounting bolts of the inhibitor switch body to the specified torque. At this time, take care to prevent dropping the switch body.
Specified torque: 10-12 Nm (7-9 ft.lbs.)
5. Loosen the nut shown in the figure, and lightly pull the end of the transaxle control in the F direction by hand.
6.Tighten the nut to the specified torque.
Specified torque: 10-14 Nm (7-10 ft.lbs.)
7. Check that the selector lever in in "N" position.
8. Check that it securely operates and functions on the transaxle side in the range which corresponds to each position of the selector lever.
