Summit Vista FWD L4-1795cc 1.8L SOHC (1992)
9.
Ohmmeter should indicate continuity.
10.
If continuity is indicated, circuit is satisfactory. Proceed to step 12.
11.
If continuity is not indicated, repair harness as necessary.
12.
Connect door latch switch harness connector, then disconnect release switch harness connector.
13.
Connect ohmmeter between release switch connector terminal 1 and ground on Colt and Summit or between terminal 2 and ground on 1992-93
Colt Vista and Summit Wagon.
14.
Observe ohmmeter while opening and closing door.
15.
Continuity should be indicated when door is open, infinite ohms should be indicated is closed.
16.
If resistance indicated is as specified, circuit is satisfactory. Proceed to step 18.
17.
If resistance indicated is not as specified, repair harness as necessary.
18.
Connect release switch harness connector, then disconnect control unit harness connector.
19.
Connect ohmmeter between control unit connector terminal 16 and ground on Colt and Summit or between terminal 15 and ground on 1992-93
Colt Vista and Summit Wagon.
20.
Observe ohmmeter while opening and closing door.
21.
Continuity should be indicated when door is open, infinite ohms should be indicated when door is closed.
22.
If resistance indicated is as specified, circuit is satisfactory. Proceed to step 24.
23.
If resistance indicated is not as specified, repair harness or replace motor and track assembly as necessary.
24.
Disconnect fasten switch harness connector.
25.
Connect ohmmeter between fasten switch connector terminal 1 and ground.
26.
Observe ohmmeter while opening and closing door.
27.
Infinite ohms should be indicated when door is open, continuity should be indicated when door is closed.
28.
If resistance indicated is as specified, circuit is satisfactory. Proceed to step 30.
29.
If resistance indicated is not as specified, repair harness as necessary.
30.
Connect fasten switch harness connector.
31.
Connect ohmmeter between control unit connector terminal 15 and ground on Colt and Summit or between terminal 16 and ground on 1992-93
Colt Vista and Summit Wagon.
32.
Observe ohmmeter while opening and closing door.
33.
Continuity should be indicated when door is open and slide anchor is not in fasten range (fasten switch On), infinite ohms should be indicated
when door is closed and slide anchor is in fasten range (fasten switch Off).
34.
If resistance indicated is as specified, circuit is satisfactory.
35.
If resistance is not as specified, repair harness or replace motor and track assembly as necessary.
Fasten Switch Test
Fig. 6 Checking Fasten Switch
1.
Remove the fasten switch.
2.
Using a suitable ohmmeter, check for continuity between switch terminals.
3.
Continuity should be present with switch knob released and no continuity should be present with the knob pushed in.
Outer Switch Test
