Summit Wagon AWD L4-1795cc 1.8L SOHC (1994)
from the harness side, because to do so will reduce the waterproof performance and result in corrosion.
Connector Continuity And Voltage Test
2. When the connector is disconnected for checking the female pin, the harness for checking the contact pressure of connector pins should be used.
Never force the insertion of a test bar, because to do so will cause poor contact.
3. When the male pin is to be checked, apply the test bar against the pin directly. Care must be taken not to Short-Circuit the connector pins.
Computer Connector
Foreword
Connectors which are loose shall be rectified by removing the female terminal from connector housing and raising its lance to establish a more secure
engagement. Removal of connector terminal used for MFI and 4 A/T control circuit shall be done in the following manner:
Computer Connector
1. Insert screwdriver [1.4 mm (0.06 in.) width] as shown in the figure, disengage front holder and remove it.
Computer Connector
2. Insert harness of terminal to be rectified deep into connector from harness side and hold it there.
Computer Connector
