Summit Wagon AWD L4-1795cc 1.8L SOHC (1994)
b. Start and run the engine until it stalls, then turn the ignition switch to OFF.
c. Disconnect the battery negative terminal.
d. Connect the fuel pump harness connector.
2. Disconnect the high pressure fuel line form the fuel rail.
CAUTION: Cover with a shop towel to avoid gasoline spillage from any residual fuel in the fuel rail or line.
3. Disconnect the fuel return line from the fuel regulator.
4. Remove the fuel rail mounting bolts.
5. Remove the fuel rail with the injectors and regulator in position. Being careful not to drop any of the injectors while removing the rail.
6. Remove the injectors from the fuel rail.
NOTE: Fuel may spill out of the fuel rail when the injectors are removed.
Injector Insulators
Fuel Rail Installation
1. Install new insulators to the intake manifold.
Injector Seals
2. Install new grommets and O-rings to the injectors.
3. Apply unleaded gasoline to the O-ring of the injector.
Injector Installation
4. While turning the injector to the left and right install it on to the fuel rail.
5. Be sure the injector turns smoothly.
NOTE: If it does not turn smoothly the O-ring may be jammed, remove the injector and re-insert it into the fuel rail. Re-check that the injector
turns smoothly.
Insulator
