Summit Wagon AWD L4-1795cc 1.8L SOHC (1994)
Seat Belt: Testing and Inspection
Vehicles For Canada
SEAT BELT WARNING SYSTEM
When the seat belt switch is ON (seat belts not buckled) with the ignition key in the ON position, the seat belt warning timer causes the seat belt
warning light to illuminate and the buzzer to sound for 4 to S seconds. If the seat belt switch is set to OFF (the seat belts buckled) during the seat
belt warning timer interval. only the buzzer is canceled.
SYSTEM INSPECTION
1. Disconnect the seat belt warning timer connector.
2. When the Y-B wire (terminal 1) and B wire (terminal 4) are connected with a jumper wire, the seat belt warning light should illuminate. If it fails
to illuminate, check the bulb, key- reminder switch and fuse.
3. Also the buzzer should sound when the R-B wire (terminal 3) and B wire (terminal 4) are connected with a jumper wire. In this condition, fasten
the buckle; if the buzzer stops sounding, the seat belt switch is good.
4. If the buzzer does not sound when terminal 3 and terminal 4 are connected with a jumper wire, check continuity of the seat belt switch. If there is
continuity in the seat belt switch, replace the buzzer.
5. After performing the above inspections, reconnect the seat belt warning timer.
6. With the ignition switch turned to IG, verify the function of the seat belt warning system.
