Summit Wagon AWD L4-1795cc 1.8L SOHC (1994)
Fig.9 Exploded View Of Tripod Type Front Drive Axle, With Inner Shaft
2. Pull drive axle from tripod joint housing, then remove snap ring and lift tripod joint spider from housing. Clean tripod joint spider and check for
wear and damage. Also check joint needle roller bearings for smooth operation. Do not disassemble tripod joint spider.
3. Wind tape around drive axle splines, then remove bands for Rzeppa type joint and remove boots from drive axle. If Rzeppa joint is to be reused,
do not wipe away grease. Check grease for contamination and clean and replace grease only if necessary. Note amount of grease removed for use
during reassembly.
4. On models with inner shaft, continue disassembly as follows:
a. Using press and support fixture No. MB991248, or equivalent, press inner shaft and seal plate out of Tripod case.
b. Using two inch steel pipe as support, press inner shaft from center bearing support.
Fig.10 Inner Shaft Removal
c. Using screwdriver, remove driveshaft side dust seal, then using same steel pipe press out center bearing and differential side dust seal.
