Summit Wagon AWD L4-2350cc 2.4L SOHC (1995)
Fig. 31 Silent Shaft Lock
4. Remove pump driven gear bolt by first removing plug on side of cylinder block, and then inserting a Phillips screwdriver into plug hold to block
silent shaft.
5. Use tool No. MD998371, or equivalent, to remove silent shaft front bearing from cylinder block, tool No. MD998372, or equivalent, to remove
right silent shaft rear bearing and tool Nos. MD998372 and MD998374, or equivalents to remove left shaft rear bearing.
6. Reverse procedure to install, noting following:
a. Use bearing installation tool Nos. MD998374 and MD998373, or equivalents, when installing silent shaft bearings.
Fig. 44 Oil Pump Drive Gears Alignment
b. Coat oil pump drive and driven gears with oil then install, aligning timing marks.
c. Install oil seals using seal installation tool No. C-0.095-A, or equivalent.
d. Install front oil seal installer tool No. MD998285, or equivalent, on crankshaft and apply oil to tool.
