Summit Wagon AWD L4-2350cc 2.4L SOHC (1995)
Fig. 36 Tensioner Set Hole Alignment
b. Push in rod slowly with vise until set holes are aligned, Fig. 36.
c. Insert a wire 0.055 inch in diameter into set holes and release tensioner from vise.
d. Install tensioner, keeping wire installed in set holes.
8. Install tensioner pulley onto tensioner arm. Position pinhole in tensioner pulley shaft to left of center bolt, then tighten center bolt finger tight.
Fig. 31 Silent Shaft Lock
9. Ensure timing marks are aligned and remove plug on side of engine block, Fig. 31. Insert a Phillips screwdriver into hole to block left silent shaft.
10. If screwdriver cannot be inserted 2.4 inch or more turn oil pump sprocket one turn and realign timing marks. Ensure screwdriver can be inserted
2.4 inches or more. Screwdriver should not be removed until installation of timing belt is complete.
11. Install timing belt as follows:
a. Install timing belt around tensioner pulley and crankshaft sprocket and secure timing belt onto tensioner pulley with your left hand.
b. Pulling timing belt with your right hand, install it around oil pump sprocket.
c. Install belt around idler pulley.
d. Install belt around camshaft sprocket.
