Summit Wagon AWD L4-2350cc 2.4L SOHC (1995)
Fig.27 Bolt Tool Installation
2. Use bolt tool No. MB990998, or equivalent to mount rear hub onto lower arm as shown.
3. Torque nut of special bolt to 145-188 ft. lbs.
4. Rotate rear hub to seat bearing.
5. With bolt tool installed, measure wheel bearing starting torque using torque wrench, adapter and socket tool Nos. MB990998, MB990685 and
MB990326, or equivalents.
6. Starting torque should be 9 inch lbs. or less and bearing must not feel rough when rotated.
Limited Slip Differential Check
1. Block front wheels and move shift lever to neutral.
2. Release parking brake completely, then raise rear wheels and support with rigid jack stand.
3. Disconnect coupling of differential and propeller shaft.
4. Rotate one wheel slowly, ensure wheel on opposite side turns in the same direction.
5. If wheel turns in the opposite direction, replace viscous unit.
