Summit Wagon FWD L4-1795cc 1.8L SOHC (1994)
2. Remove lockpin, bushing, caliper support, guide pin and lockpin boots.
3. Remove boot ring using a suitable flat blade screwdriver.
4. Position a shop towel in caliper body, then apply compressed air through the brake hose fitting hole to remove piston and dust boot. Apply air
gently.
5. Remove piston seal using finger tips.
CAUTION: Do not use screwdriver or other tool to prevent damage to inner cylinder.
6. Reverse procedure to assemble, noting the following:
a. Inspect cylinder and piston for wear or damage and/or corrosion. Inspect caliper body and sleeve for wear.
b. Apply suitable brake fluid to inner cylinder, then install piston seal into cylinder groove. Do not wipe special grease from piston seal.
c. Apply suitable brake fluid to piston and insert into cylinder without twisting.
d. Fill piston edge with grease from seal and boot repair kit or equivalent, then install piston boot.
e. Lubricate sliding surface of lockpin and guide pin boots, caliper support and bushing with grease from seal and boot repair kit.
f.
Install guide and lockpins with their head marks matched with identification marks on caliper body.
Rear
1. Remove caliper assembly as described under "Caliper Replacement".
