Summit Wagon FWD L4-1795cc 1.8L SOHC (1994)
Alignment: Service and Repair
Rear Alignment
REAR WHEEL ALIGNMENT
NOTE: On vehicles with aluminum wheels, attach camber/caster to driveshaft using tool No. MB991004, or equivalent.
CAMBER
Rear camber is preset during vehicle assembly and cannot be adjusted. If camber is not within specifications, check for worn or damaged
suspension component, and damaged or deformed floor pan or body and repair as needed.
TOE-IN
Toe is adjustable by rotating outer and inner arm mounting bolts. If toe-in is not within specifications, rotate left and right outer arm and inner
arm bolts, each by same amount, to perform adjustment. An adjustment of approximately 0.08 inch (2 mm) will be made when outer arm and
inner arm bolts are turned equivalent of 1 alignment mark.
