Summit Wagon FWD L4-1795cc 1.8L SOHC (1994)
Self Power Test Light
2. Self-Power Test Light
A self-power test light consists of a bulb, battery and lead wires connected in series. It is used to check continuity or grounding.
Jumper Wire
3. Jumper wire
A jumper wire is used to close an open circuit. Never use one to connect a power supply directly to a load.
Voltmeter
4. Voltmeter
A voltmeter is used to measure the circuit voltage. Normally, the positive (red lead) probe is applied to the point of voltage measurement and the
negative (black lead) probe to the body ground.
Ohmmeter
5. Ohmmeter
An ohmmeter is used to check continuity or measure resistance of a switch or coil. If the measuring range has been changed, the zero point must be
adjusted before measurement.
Wire and Cable Testing
