Summit Wagon FWD L4-1795cc 1.8L SOHC (1994)
Throttle Body
DISASSEMBLY AND REASSEMBLY
Disassembly steps
1. Throttle position sensor (with closed throttle position switch)
2. Idle air control motor.
3. Gasket
4. Throttle body
5. Accelerator cable bracket
ASSEMBLY CAUTIONS:
-
When loosening a Phillips screw which has been firmly tightened, use a Phillips screwdriver that is an exact fit for the screw.
-
Do not remove the throttle valve.
-
Be careful when removing the throttle position sensor and idle air control motor mounting screws, as adhesive has been applied to these
screws.
SERVICE POINT OF REASSEMBLY
INSTALLATION OF THROTTLE POSITION SENSOR
1. Set the throttle position sensor to the throttle body as shown in the diagram.
2. Turn throttle position sensor 9O°in the counterclockwise direction to set it, and tighten screws.
3. Check for continuity across terminals ffi2 (closed throttle position switch) and G1 (ground) with the throttle valve both fully closed and fully open.
INSTALLATION
1. Install a new gasket.
2. Install the throttle body and torque the bolts in a cross-pattern
