Summit Wagon FWD L4-1795cc 1.8L SOHC (1994)
MOTOR, RELEASE SWITCH AND FASTEN SWITCH
1. Disconnect the automatic seat belt motor relay connector.
2. Connect the battery to the connector (shown in the figure) at the automatic seat belt motor relay harness side, and, as shown in the table below,
check to be sure that the slide anchor functions normally, and also check for continuity of each switch.
CAUTION: The slide anchor must be activated all the way to the fasten position or the release position, without stopping part way on the guide
rail.
NOTES:
1. (+)----(-) indicates terminals to which battery voltage is applied.
2. ()----() indicates that there is continuity between the terminals.
