Talon AWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1997)
Lash Adjuster: Testing and Inspection
Leak Down Test
CAUTION:
1. The lash adjuster is a precision part. Keep it free from dust and other foreign matter.
2. Do not disassemble lash adjuster.
3. When cleaning lash adjuster, use clean diesel fuel only.
NOTE: Diesel fuel temperature should be 15 - 20° C (59 - 68° F).
1. Immerse the lash adjuster in clean diesel fuel.
2. While lightly pushing down inner steel ball using the special tool (MD998442), move the plunger up and down for or five times to bleed air. Use of
the retainer helps the air bleeding of the rocker arm mounted type lash adjuster.
3. Remove the special tool and press the plunger. If the plunger is hard to be pushed in, the lash adjuster is normal. If the plunger can be pushed in all the
way readily, bleed the lash adjuster again and test again. If the plunger is still loose, replace the lash adjuster.
CAUTION: Immediately after air bleeding, hold lash adjuster upright to prevent fuel from spilling.
4. After air bleeding, set lash adjuster on the special tool (Leak down tester MD998440).
