Talon AWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1997)
value.
E = A + B + C - 1/2 D - 86.00 mm (3.39 inch)
11. Fit the selected drive pinion rear shim(s) to the drive pinion, and press-fit the drive pinion rear bearing inner race by using the special tool.
D. Drive pinion preload adjustment. (^)
Adjust the drive pinion turning torque by using the following procedures:
1. Fit the drive pinion front shim(s) between the drive pinion spacer and the drive pinion front bearing inner race.
2. Tighten the companion flange to the specified torque by using the special tools.
NOTE: Do not install the oil seal.
3. Measure the drive pinion turning torque (without the oil seal) by using the special tools.
Standard Value New:
Bearing lubrication: None (with rust-prevention oil).
Rotation torque (starting friction torque): 0.9-1.2 Nm (8-10 inch lbs.)
Standard Value New/Reused:
Bearing lubrication: Gear oil application.
Rotation torque (starting friction torque): 0.4-0.5 Nm (3-4 inch lbs.)
4. If the drive pinion turning torque is not within the range of the standard value, adjust the turning torque by replacing the drive pinion front
shim(s) or the drive pinion spacer.
NOTE: When selecting the drive pinion front shims, if the number of shims is large, reduce the number of shims to a minimum by
selecting the drive pinion spacers.
