Talon AWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1997)
Wheel Bearing End Play Check
1. Install the special tool to the front hub assembly and tighten the nut to the specified torque 196 - 255 Nm (145 - 188 ft. lbs.).
2. Measure the play in the hub axial direction.
3. If the limit value of 0.05 mm (0.002 inch) in the wheel bearing end play cannot be obtained, replace the front hub assembly.
INSTALLATION
1. Follow removal steps in reverse order for installation, noting the following.
2. Install the drive shaft washer in the specified direction.
3. Use the special tool to tighten the drive shaft nut.
CAUTION: Before securely tightening the drive shaft nuts, make sure there is no load on the wheel bearings.
3. If the position of the cotter pin holes does not match tighten the nut up to 255 Nm (188 ft. lbs.) in maximum.
4. Install the cotter pin in the first matching holes and bend it securely.
