Talon FWD L4-1997cc 2.0L DOHC (1990)
Figure 2
3.
Begin the installation of the headliner molding at either end of the roof flange. Position the molding as shown in Figure 1, with a gap between the
molding and the headliner. Work the molding into position bending it at approximately 901 to the flange while pushing the loose end onto the
flange as shown in Figure 2.
Figure 3
4.
When the molding is completely on the flange, roll the molding toward the headliner to cover the gap and meet the headliner as shown in Figure 3.
5.
Install the A-pillar trim.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
23-10-50-91
. . . . . . . . . . . . . .0.3 Hrs.
FAILURE CODE: Wavy Surface Uneven.
