Talon FWD L4-1997cc 20L DOHC Intake Manifold Specifications
Fig. 11 Intake Manifold Assembly (Part 2 Of 2). 2.0L/4-122
REMOVAL
Remove intake manifold in numbered sequence, referring to Fig. 10 on 1.8L/4-107 engines and Fig. 11 on 2.0L/4-122 engines, noting the
following:
1.
Drain coolant as follows:
a. Place instrument panel temperature control lever in Hot position.
b. Carefully remove radiator cap.
c. Remove radiator drain plug.
2.
On 1.8L/4-107 engines, when removing upper radiator hose, mark hose clamp in relation to hose for assembly reference.
3.
On all models, before disconnecting high pressure fuel line, relieve fuel system pressure as follows:
a. Disconnect fuel pump harness connector at fuel tank.
b. Start engine and let it run until it stalls, then turn ignition switch to off.
c. Disconnect negative battery cable.
d. Reconnect fuel pump harness connector.
4.
Remove delivery pipe, fuel injector and regulator as an assembly.
INSPECTION
Inspect intake manifold and air intake plenum (if equipped) as follows:
1.
Check for damage, cracks or defects.
2.
Ensure coolant and jet air passages are clear.
3.
Check installation surfaces with a straightedge. Replace if deflection exceeds .012 inch.
