Talon FWD L4-1997cc 2.0L DOHC (1990)
Check The Tie Rod For Swing Resistance
(1) Give 10 hard swings to the tie rod.
(2) Measure the tie rod swing resistance with a spring balance.
Standard value:
8-20 N (1.8-4.4 lbs. of force).
2-5 Nm (17-43 in/lbs.).
(3) If the measured value exceeds the standard value, replace tie rod assembly.
Note: Even if the measured value is below the standard value, the tie rod which swings smoothly without excessive play may be used.
Installation
Installation Steps
Note: When installing the mounting rubber, align the projection of the mounting rubber with the indentation in the cross member to install the gear
box.
1. Mounting rubber.
2. Gear box assembly.
3. Front exhaust pipe.
4. Center member rear mounting bolts.
5. Front roll stopper mounting bolt.
6. Stabilizer bar bracket.
7. Stay.
8. Tie-rod end.
9. Tie-rod end and knuckle connecting nuts.
10. Cotter pin.
11. Joint assembly and gear box connecting bolt.
Post-installation Operation
-
Checking of steering wheel position with wheels straight ahead.
-
Adjustment of the front wheel alignment.
Removal
Pre-removal Operation
-
Draining of the Power Steering Fluid.
Removal Steps