Talon FWD L4-1997cc 2.0L DOHC (1990)
6. Using the special tool, disconnect the tie rod end from the knuckle.
Caution:
a. Be sure to tie the cord of the special tool to the nearby part.
b. Loosen the nut but do not remove it.
7. Stay.
8. Stabilizer bar bracket.
9. Front roll stopper mounting bolt.
10. Center member rear mounting bolt.
11. Front exhaust pipe.
12. Gear box assembly.
a. Move the rack completely to the right and then remove the gear box from the crossmember.
b. While tilting the gear box downward, remove it to the left.
Caution: When removing the gear box, pull it out carefully and slowly to avoid damaging the boots.
13. Mounting rubber.
Inspection
Inspection:
Gear Box For Total Pinion Torque
Using the special tools, rotate the pinion gear at the rate of one rotation in approximately 4 to 6 seconds to check the total pinion torque.
-
Standard value: 0.6-1.3 Nm (5-11 in/lbs).
Note:
-
Measure the pinion torque through the whole stroke of the rack. If the measured value is not within the standard range, first adjust the rack support
cover, and then check the total pinion torque again.
-
If the total pinion torque cannot be adjusted to within the standard range by adjusting the rack support cover, check the rack support cover, rack
support spring, rack support and replace any parts necessary.