Talon FWD L4-1997cc 2.0L DOHC Turbo (1995)
Sunroof / Moonroof Handle Assembly: Customer Interest
Sunroof - Does Not Close Completely
NO: 23-80-94
GROUP: Body
DATE: Oct. 28, 1994
SUBJECT:
Sunroof Lever Latch Pin
MODELS:
1995 (FJ) Talon/Avenger/Sebring
NOTE:
THIS BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO SEP. 16, 1994.
SYMPTOM/CONDITION:
The pivot pin in the sun roof lever mechanism may come out during normal operation. This can cause interference which prevents the sunroof from
closing completely.
PARTS REQUIRED:
2
MR217021
Pivot Pin
AR MR199785
Guide Rail Assembly - LH
AR MR199786
Guide Rail Assembly - RH
REPAIR PROCEDURE:
1.
Power the sunroof to the vent position. Make sure the pivot pin is aligned with the access hole (Figure 1).
NOTE:
IF ARM MECHANISM DOES NOT HAVE AN ACCESS HOLE (EARLY PRODUCTION), THEN REPLACE THE GUIDE RAIL ASSEMBLY.
2.
Following the proper procedure, remove sunroof glass.
The following procedures apply to both the right and left sides of the sun roof guide arm assemblies.
3.
With a trim stick or other suitable tool, slide the locker arm outboard (push the arm as far outboard as possible to prevent damage to locker arm).
4.
Insert a punch through the access hole and push the pin out (far enough to remove it with pliers).
