Talon FWD L4-1997cc 2.0L DOHC Turbo (1995)
Impact Sensor: Customer Safety Information
Component Service
If the SRS components are to be removed or replaced as a result of maintenance, troubleshooting, etc, follow each procedure.
Cautions
1. SRS components should not be subjected to heat over 93°C (200°F), so remove the front impact sensors, SRS diagnosis unit, air bag
modules and clock spring before drying or baking the vehicle after painting. Recheck SRS system operability after re-installing them.
2. If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry
place until they are reinstalled.
SRS Diagnostic Unit
Cautions
1. Never repair or disassemble a front impact sensor. If faulty, replace it.
2. Handle the front impact sensors very carefully, taking care not to drop them or otherwise subject them to impact. If a sensor is seen to be
dented, cracked, deformed or rusted, replace it with a new one
3. Replace sensors with new ones after the air bags have deployed.
