eagle Workshop Repair Guides

Eagle Workshop Service and Repair Manuals

Brake Fluid Level Sensor/Switch > < Brake Caliper|Removal and Installation|Page 4063
Page 1
background image

Brake Fluid: Specifications

BRAKE FLUID 

Specification  ......................................................................................................................................................................................  DOT 3 or DOT 4

Standard .........................................................................................................................................................................................................  SAE J1703

NOTE: The brake fluid used in this vehicle must conform to DOT 3 specifications and SAE J1703 standards. DOT 4 brake fluid is acceptable. No
other type of brake fluid is recommended or approved for usage in the vehicle brake system. Use only Mopar brake fluid or an equivalent from a
tightly sealed container.

CAUTION: Never use reclaimed brake fluid or fluid from a container which has been left open. An open container of brake fluid will absorb
moisture from the air and contaminate the fluid.

CAUTION: Never use any type of a petroleum based fluid in the brake hydraulic system. Use of such type fluids will result in seal damage of the
vehicle brake hydraulic system causing a failure of the vehicle brake system. Petroleum based fluids would be items such as engine oil, transmission
fluid, power steering fluid, etc.

Brake Fluid Level Sensor/Switch > < Brake Caliper|Removal and Installation|Page 4063