Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
-
Post-installation Operation
-
Timing Belt Front Upper Cover Installation
-
Engine Adjustment
Follow removal steps outlined in illustration.
Removal Service Points
A. Exhaust Camshaft Sprocket/ Intake Camshaft Sprocket Removal.
1. Use a wrench at the hexagonal part of the camshaft (to prevent the crankshaft from turning) to loosen the camshaft sprocket bolt.
2. Remove the camshaft sprockets.
B. Front Camshaft Bearing Cap/ Camshaft.
Bearing Cap/ Rear Camshaft Bearing (R.H.)/ Rear Camshaft Bearing (L.H.) Removal
1. Loosen the bearing cap installation bolts in two or three steps.
2. Remove the bearing cap.
NOTE: If the bearing cap is difficult to remove, use a plastic hammer to gently tap the rear part of the camshaft, and then remove.
INSTALLATION
Installation Service Points
A. Intake Camshaft / Exhaust Camshaft.
1. Install the camshafts on the cylinder head.
CAUTION: Do not confuse the intake side and the exhaust side.
