Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
NOTE: Install new camshafts using the following procedure.
1. Remove the rocker arms.
2. Lay the camshafts on the cylinder head and install the bearing caps.
3. Check that the camshaft can be easily turned by hand.
4. After checking, remove the bearing caps and the camshafts, and install the rocker arms.
2. The camshaft's dowel pins should be at the positions shown in the figure.
B. Rear Camshaft Bearing Cap (R.H.)/ Rear Camshaft Bearing Cap (L.H.)/ Camshaft Bearing Cap/ From Camshaft Bearing Cap Installation.
Tighten the bearing cap installation bolts to the specified torque in two or three steps.
CAUTION: Tighten uniformly, otherwise the rocker arms will not be straight.
C. Camshaft Oil Seal Installation.
Use the special tool to drive the camshaft oil seal into position carefully.
D. Camshaft Position Sensing Cylinder/ Camshaft Position Sensor Support Installation.
1. Install the camshaft position sensing cylinder to the end of the camshaft as shown in the illustration.
