Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
CAUTION: the removed air bag module should be stored in a clean, dry place with the pad cover facing up.
INSTALLATION SERVICE POINTS
Pre-installation Inspection
1. When installing the new air bag module and clock spring, refer to "INSPECTION".
CAUTION: Dispose of an air bag module only according to the specified procedure. See: Service and Repair.
2. Connect the battery (-) terminal.
3. Connect the scan tool to the data link connector, then check diagnostic codes.
CAUTION: Turn the ignition switch off before disconnecting or connecting the scan tool.
4. Turn the ignition key to the "ON" position.
5. Conduct diagnostic test mode using the scan tool to ensure entire SRS operates properly, except open circuit of air bag module (diagnostic trouble
code No.22, 25).
6. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal to prevent accident connection and air
bag deployment.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. See: Service Precautions/Vehicle
Damage Warnings
Post-installation Inspection
1. After installing the clock spring, the steering wheel, the column covers and the air bag module, check steering wheel for noise, binds or difficult
operation.
2. Reconnect the negative battery terminal. Turn the ignition key to the "ON" position. floes the "SRS" warning light illuminate for about 7 seconds,
turn OFF and then remain OFF? If yes, SRS system is functioning properly. See: Testing and Inspection.
