Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
Step 3 - Steering Wheel Removal
CAUTION: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.
INSTALLATION SERVICE POINTS
Pre-installation Inspection
1. When installing the new air bag module and clock spring, refer to "INSPECTION".
CAUTION: Dispose of an air bag module only according to the specified procedure. See: Restraint Systems/Air Bag Systems/Service and
Repair.
2. Connect the battery (-) terminal.
3. Connect the scan tool to the data link connector, then check diagnostic codes.
CAUTION: Turn the ignition switch off before disconnecting or connecting the scan tool.
4. Turn the ignition key to the "ON" position.
5. Conduct diagnostic test mode using the scan tool to ensure entire SRS operates properly, except open circuit of air bag module (diagnostic trouble
code No.22, 25).
6. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal to prevent accident connection and air
bag deployment.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. See: Restraint Systems/Air Bag
Systems/Service Precautions/Vehicle Damage Warnings
Step 3 - Steering Wheel Installation
1. Before installing the steering wheel, turn the vehicle's front wheels to the straight-ahead position and align the mating marks of the clock spring.
CAUTION: When installing the steering wheel, ensure that the harness of the clock spring does not become caught or tangled.
2. After installing, turn the steering wheel all the way in both directions to confirm that steering is normal.