Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
7. Check that the crimped width (B) is within 2.4 - 2.8 mm (0.094 - 0.110 inch).
a. When more than 2.8 mm (0.110 inch):
-
Readjust the dimension (W) of step (4) to the value calculated by the following equation, and repeat step (6).
-
W = 5.5 mm (0.217 inch) - B
-
Example: If (B) is 2.9 mm (0.114 inch), (W) is 2.6 mm (0.102 inch).
b. When less than 2.4 mm (0.094 inch):
-
Remove the B.J. boot band, readjust the dimension (W) of step (4) to the value calculated by the following equation, and use a new B.J.
boot band to repeat steps (5) to (6).
-
W = 5.5 mm (0.217 inch) - B
-
Example: If (B) is 2.3 mm (0.091 inch), (W) is 3.2 mm (0.126 inch).
8. Check that the B.J. boot band is secured correctly. If the band is secured incorrectly, repeat steps (5) to (7) to replace it.
9. Apply the specified amount of grease to the boot.
10. Install the B.J. boot to adjust the clearance (C) between the B.J. boot end and the stepped phase of the B.J. housing is within 0.1 - 1.55 mm (0.004
- 0.061 inch).
11. Adjust the opening dimension (W) to 3.2 mm (0.126 inch) as mentioned at the step (4).
