Talon FWD L4-1997cc 2.0L DOHC VIN Y SMFI (1997)
C.
Calculate clearance "A" by taking B, C, and D measurements (A = B - C - D) as shown in figure 3.
2.
The specification for clearance is 0.65 to 0.85 mm (0.0256 to 0.0335 in).
NOTE:
WHEN VACUUM IS APPLIED TO THE BOOSTER, THE CLEARANCE WILL BE REDUCED TO 0.1 TO 0.3 MM (0.004 TO 0.012 IN).
3.
If the clearance is not within specification, turn the push rod screw to adjust the length to specification (Figure 4).
Measuring Hub End Play (Front or Rear)
1.
Remove and suspend the caliper out of the way (disc brakes)
2.
Remove rotor from the hub or brake drum from hub.
3.
Attach a dial indicator as shown in figure 5 and measure end play by moving the hub in an axial (in/out) direction.
4.
If end play exceeds 0.05 mm (0.002 in.) replace the hub assembly.
Measuring Rotor Thickness Variation (Front or Rear)
NOTE:
CHECK VARIATION WHILE THE BRAKES ARE COLD.
1.
Remove the tire, caliper and brake pads. Install the wheel nuts onto the studs to hold the rotor positively in place. Tighten the nuts uniformly.
2.
Clean the rotor with MOPAR brake parts cleaner p/n 04897150AA.
