Talon FWD L4-1997cc 2.0L DOHC VIN Y SMFI (1997)
2. Wrap plastic tape around the spline part on the drive shaft, and then install the B.J.boot band (small) and B.J.boot.
3. Install the smaller side of the B.J. boot band so that one shaft groove can be seen.
4. Turn the adjusting bolt of the special tool to adjust the opening dimension (W) to 2.9 mm (0.114 inch).
NOTE:
1. The dimension (W) is adjusted by approximately 0.7 mm (0.028 inch) per one turn.
2. Do not turn the adjusting bolt more than one turn.
5. Place the boot band (small) along the protruding portion, and install it so that there is some clearance (A) along the other side.
6. Use the special tool to crimp the B.J. boot band (small).
CAUTION:
1. Hold the drive shaft perpendicularly, and use the special tool to crimp the B.J. boot band securely.
2. Crimp the B.J. boot band until the special tool touches the stopper.
