Vision V6-201 3.3L (1993)
Fig. 9 Webbing Material To Generator Bracket Installation
3.3L/V6-201
1.
Mount fixture across engine compartment.
2.
Mount nylon webbing material, to the following locations.
a. Remove bolt attaching A/C compressor bracket to front of engine. Install webbing material hook on A/C compressor bolt then install bolt and
tighten.
b. Loosen, do not remove, generator to engine bolt, remove spacer between generator and engine. Install webbing material hook between
generator and engine then install and tighten bolt.
c. Remove electronic ignition coil and mounting bracket bolt from rear of engine. Install webbing material hook on bracket bolt and re-install and
tighten bolt. Route webbing material between fuel injector rail and valve cover.
d. Mount remaining piece of webbing material to threaded hole on back of left cylinder head using a suitable bolt.
3.
Securely attach pieces of webbing material to hook on engine holding fixture. Tighten hook on fixture until all slack is removed from all webbing
material.
