Vision V6-201 3.3L (1993)
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Replace fuel rail
14787182
1.2 hours
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See the Warranty Administration Manual Recall Claim Processing Section for complete recall claim processing instructions.
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills Michigan 48326-2757
Following the above procedures will expedite the processing or your claim.
If you have any questions or need assistance in completing this action please contact your Zone Service Office.
Service Procedure
WARNING:
The fuel system is under constant fuel pressure even with the engine off. Fuel pressure must be released before servicing the fuel rail.
1.
With the ignition key in the OFF position disconnect the battery.
Note:
To enhance customer satisfaction remember to record all radio settings before disconnecting the battery and to reset all electronic memory
(clock radio settings etc.) when you have completed the service procedure.
2.
Remove the fuel tank filler cap to release the fuel tank pressure.
3.
Remove the protective cap from the pressure test port on the fuel rail (Figure 1).
