Vision V6-201 3.3L (1993)
Windshield Wiper Transmission: Service and Repair
Fig. 10 Wiper Motor And Linkage Module
WINDSHIELD WIPER MOTOR
REPLACE
1. Remove wiper arms and blades and disconnect hoses from in-line connector.
2. Remove rear hood seal with cowl top plastic screen and disconnect washer hose at in-line connector.
3. Disconnect motor connector at back side of housing.
4. Remove wiper housing retaining screws then the wiper housing module.
5. Disconnect and remove wiper drive link from motor crank.
6. Remove motor mounting screws then lift motor and mounting plate out of housing.
7. Disconnect motor harness grommet from housing.
8. Reverse procedure to install, torquing crank motor nut to 89 - 124 in. lbs. and motor mounting screws to 89 - 106 in. lbs.
