Vision V6-215 3.5L SOHC (1995)
Cruise Control Switch: Service and Repair
The speed control switches are mounted in the steering wheel and wired through the clock spring device under the steering wheel hub.
If removal of air bag module is necessary, refer to Air Bag/Service and Repair.
1. Turn ignition switch to Off position.
2. Remove two screws from back side of each switch on steering wheel.
3. Rock switch away from air bag or horn pad while lifting switch out of steering wheel. Do not point air bag module toward yourself or others when
performing this operation to prevent injury in case of accidental deployment of air bag module.
4. Disconnect 2-way electrical connector.
5. Reverse procedure to install, sliding the forward edge of switch under air bag or horn pad. Line up locating pins on switch with holes in steering
wheel frame. Do not point air bag module toward yourself or others when performing this operation to prevent injury in case of accidental
deployment of air bag module.
