Vision V6-215 3.5L SOHC (1995)
Timing Belt Installation
7. Install the timing belt starting at the crankshaft sprocket going in a counterclockwise direction. Install the belt around the last sprocket. Maintain
tension on the belt as it is positioned around the tensioner pulley. Each camshaft sprockets mark should still fall between the cover marks.
8. Holding the tensioner pulley against the belt, install the tensioner into the housing and tighten to 28 Nm (250 inch lbs.).
9. When tensioner is in place, pull retaining pin to allow the tensioner to extend to the pulley bracket.
10. With number 1 piston at TDC, hold the camshaft sprocket hex with a 36 mm (1 7/16 inch) wrench and tighten the camshaft bolts to 102 Nm (75 ft.
lbs.) plus a 90 degree turn for the Right side and 115 Nm (85 ft. lbs.) plus a 90 degree turn for the Left side.
11. Remove dial indicator and install spark plug and tighten to 28 Nm (20 ft. lbs.).
12. Remove camshaft alignment special tools 6642-A, or equivalent and install cam covers and O-rings. Tighten fasteners to 28 Nm (250 inch lbs.).
13. Install timing belt covers. See: Timing Cover
14. Install crankshaft damper.
15. Install accessory drive belts.
16. Fill cooling system.
